Leaky pipes are a huge problem. They may wreak havoc on your home, destroying ceilings, floors, walls, carpets, and furniture, among other things. In addition, mold and mildew can thrive in damp environments. All of these issues can add up to a lot of money in repair bills. Not only that but leaking pipes wastewater, meaning you’re spending a lot more on your water bill for the water you’re not utilizing. Luckily for you, Westhills plumbing and heating, your trusted Calgary plumber will tell you dome of the cause for leaky pipes.
Pipes can last for a long time, but they’re not meant to do so. Older pipes are composed of materials like iron, which are far more prone to corrosion. In addition, the pipe weakens and begins to break down due to pollution, which can lead to a leak in the future. It may be necessary to replace older pipes with modern ones if you have older ones. The majority of newer pipes are composed of corrosion-resistant copper or plastic. While copper pipes will not survive indefinitely, you will not have to worry about corrosion causing them to rust.
A Root from a Tree Has Intruded
Leaks can start from the outside of the house as well as the interior. An entering tree root is one of the most typical reasons for a leak that begins outside. While the origins of the tree in your yard may not have been a concern when the pipes were first installed, as the tree grows, they may eventually make their way across. If the root gets inside the tube and destroys it, the water will flow out into the earth. A drop in water pressure is one of the most common signs of a leak. If you observe a dip in your yard combined with a wet area (and there’s a tree nearby), the tree’s root may have damaged the pipe.
Seals that have been broken or damaged
Seals are found in a variety of locations throughout your plumbing system. Rubber seals should have been installed around your pipes where they link to faucets or other fixtures. The purpose of these seals is to keep the connection dry. The issue is that rubber seals aren’t designed to last indefinitely. They can wear out over time or broken if they are damaged. As a result, water can escape. The presence of moisture or condensation near a fixture could indicate a faulty, damaged, or broken seal.
Corrosion, such as rust, can occur in pipes over time. Corrosion is a chemical reaction that occurs when metal reacts with the environment’s chemicals. Corrosion can be caused by what is contained in your water in the case of your pipes. Corrosion weakens your metal pipes by eating away at them. Corrosion can also lead to the formation of holes, allowing water to escape. If your pipes were installed several years ago, they might be more prone to corrosion than newer lines. Corrosion can also occur when the pH of the water or the mineral content of the water is off. 0
There’s a Blockage
Clogs are an annoyance. However, they can also be the source of a leaking pipe. Pressure might build up behind a clog if when not addressed. This pressure can cause a line to crack or break if it is too high. In addition, corrosive compounds, such as cleansers, can be found in some forms of clogs, speeding up pipe damage and eating through the metal. If you have a clog in any of your home’s pipes, you should clear it out as quickly as possible.
Water Pressure Is Too High
Intense water pressure may feel wonderful in the shower, but it can be harmful to your pipes if you have too much. The greater the power with which water passes through your pipes, the greater the chance of damage. High water pressure can cause a line to explode in extreme instances. On the other hand, when the water pressure is slightly off, you may only notice things like the occasional leak at the fixture shortly before the water is off.
Joints that have been damaged
The weakest parts of your pipes are usually the joints. They are the curved sections of the pipes that cause the water to change direction to reach its destination. In some circumstances, the joints can deteriorate over time, allowing a leak to emerge. Strange noises while the water, notably hot water, is running are the first indicator that anything is wrong with the joints. For example, there may be a clacking or slamming sound coming from the pipes.
A leaking pipe is the last thing anyone wants to deal with. Taking care of it as soon as you see it, on the other hand, can help you save both your property and your money. If you notice any indicators of a leak, such as a leaky faucet, increases in your water bill, or a musty odour, it’s time to contact a Calgary plumber as soon as possible. Westhills Plumbing and Heating is here to help you!